To Slovenia:

Orders under 80 € - the shipping cost is 5,00 €

Orders over 80 € - the delivery is free of charge

To EU Member States:

Orders under 120 € - the shipping cost is 12,90 €

Orders over 120 € - the delivery is free of charge

To the rest of the world:

The shipping cost is 24,90 €.

RUNNING-IN PROCEDURE

In order to ensure optimal braking performance and the best racing experience each new set of brake pads has to undergo running-in procedure when assembled in the braking system. 

During this important phase brake pad surface is being adjusted against the brake disc surface and a transfer layer on the brake disc surface is being developed. This significantly affects friction and wear performance of the brake couple.

Sinter recommends the following running-in procedure:

1. Make sure the brake disc and the brake pads have been properly installed.
2. Brake disc and brake pad surface should be clean and dry.
3. Start slowly and brake lightly pushing the pedal for a couple of seconds in order to slow down without making a complete stop. Repeat 20 times.
4. Allow brakes to cool down.
5. Proceed with gradual speed increase for 5-10 laps. During this phase brake moderately without any hard stops. Allow the brakes to cool after each lap.
6. Finish the running-in procedure with high speed and hard braking for 2-3 laps.
7. Allow the brakes to cool down.

Get ready to race! Your brakes already are.