These cookies are strictly necessary for the operation of the site, you can disable them by changing the settings of your browser but you will not be able to use the site normally.
These cookies provide necessary information to applications of the website itself or integrated by third parties, if you disable them you may find some problems in the operation of the page.
The user is informed that they have the option of setting their browser so that they are informed of the receipt of cookies and may, if they wish, prevent it from being installed on the hard disk.
Below, we provide links to different browsers through which you can configure:
This material is designed for maximum go-kart braking loads. It performs best with grey cast iron braking disks.
POWERFUL INITIAL BITE
SUITABLE FOR RACING APPLICATION
In order to ensure optimal braking performance and the best racing experience each new set of brake pads has to undergo running-in procedure when assembled in the braking system.
During this important phase brake pad surface is being adjusted against the brake disc surface and a transfer layer on the brake disc surface is being developed. This significantly affects friction and wear performance of the brake couple.
Sinter recommends the following running-in procedure:
Make sure the brake disc and the brake pads have been properly installed.
Brake disc and brake pad surface should be clean and dry.
Start slowly and brake lightly pushing the pedal for a couple of seconds in order to slow down without making a complete stop. Repeat 20 times.
Allow brakes to cool down.
Proceed with gradual speed increase for 5-10 laps. During this phase brake moderately without any hard stops. Allow the brakes to cool after each lap.
Finish the running-in procedure with high speed and hard braking for 2-3 laps.